Here is the synopsis of our sample research paper on Statistical Control Process for Ida’s Pills. Have the paper e-mailed to you 24/7/365.
                                            
Essay / Research Paper Abstract
This 4 page paper is based on data supplied by the student. The use of statistical control process is used to assess the time it takes a patient to take a set of pills. The process is placed into a chart and then analyzed. The bibliography cites 1 source. 
                                                
Page Count: 
                                                4 pages (~225 words per page)
                                            
 
                                            
                                                File: TS14_TESPCida.rtf
                                            
                                            Buy This Term Paper »
                                          
                                             
Unformatted sample text from the term paper:
                                                    
                                                
                                                    time taken to take the pills over a period of 26 days the first stage of the statistical process control is to chart the data, this has been done indicating  
                                                
                                                    the time take to take the pills. The data is provided from days 1 - 26, the first two days were those were the process was being learned and was  
                                                
                                                    accompanied by some training, so it is possible to argue that these are not data point that should be included, due to their position as training points. However, they are  
                                                
                                                    being included in the data to give a full analysis.  	The x axis is the independent variable, in this case the days, the Y axis is the time taken  
                                                
                                                    in minutes.   	The areas that show a potential out of control or deviant result are the earlier areas of the chart where the process was being learnt, the  
                                                
                                                    chart then shows that there is a very uniform result being achieved following the initial introduction stage. This charting be useful as there is the potential to measure the process  
                                                
                                                    against other potential variables in order to assess whether or not there is a relationship between any other variables, h ere there only appears to be a link to the  
                                                
                                                    initial training and getting used to the process. This is supported by analysing the data.         Looking at this there are 26 data  
                                                
                                                    points and the range is the highest point less the lowest point, so the range is 5.  Next we can calculate the mean is 6.07 and we also need  
                                                
                                                    to look at the standard deviation, the calculation for this is shown below is each of the data points put into a calculation of the square route of each of  
                                                
                                                    ...